CL settings1981SVC 440 795 M0100Activating the passwordYou can activate a valid password in three different ways:• automatically when the logic relay is switched on again• automatically after a protected circuit diagram is loaded• via the password menu.X Press DEL and ALT to call up the system menu.X Open the password menu via the SECURITY… menuThe logic relay will only show this password menu if apassword is present.X Select ACTIVATE PW and press OK.The password is now active. The logic relay willautomatically return to the status display.You must unlock the logic relay with the password beforeyou implement a protected function, enter a protected menuor the system menu.CHANGE PWACTIVATEh Make a note of your password before activating it. If thepassword is no longer known, the logic relay can beunlocked (DELETE FUNCT is not active), but the circuitdiagram and data settings are lost. The interface must notbe disabled.Attention!The following applies if the password is not known or islost and the delete password function is disabled: Thedevice can only be reset to the factory setting at themanufacturers. The program and all data will be lost.
