4. Activate BLOCK binary input and check that the outputs TEMPALM, TEMPLO,ALARM and LOCKOUT disappear.5. Reset the BLOCK binary input.6. Make sure that temperature lockout condition exists and then activate the resetlock out input RESETLO and check that the outputs TEMPLO and LOCKOUTreset.13.12.2.3 Completing the test GUID-1A0D8AF0-4C48-45E8-B31D-96734ED1A4D2 v1Continue to test another function or end the test by changing the TestMode setting toOff. Restore connections and settings to their original values, if they were changed fortesting purposes.13.12.3 Breaker monitoring SSCBR GUID-10D26C82-79FF-4EAD-AE4A-2F2DBE965087 v2Prepare the IED for verification of settings outlined in section “Testing the IEDoperation”.The Signal Monitoring tool in PCM600 shows the service values that are available onthe Local HMI as well.Values of the logical signals belong to the breaker monitoring are available on the localHMI under: Main menu/Test/Function status/Monitoring/BreakerMonitoring/SSCBR:x13.12.3.1 Verifying the settings GUID-962A344D-5F8D-49A6-B3AC-29C7FEED0A3D v41. Connect the test set for the injection of a three-phase current to the appropriatecurrent terminals of the IED.2. If current need to be injected for a particular test, it should be done in the phaseselected by the PhSel parameter.3. Follow the sequence for positioning the auxiliary contacts before testing:POSCLOSE 0 1 0POSOPEN 0 0 14. Test of CB contact travel time4.1. Test the set timing defined by OpenTimeCorr, CloseTimeCorr, tTrOpenAlmand tTrCloseAlm.4.2. Change the status of the auxiliary contacts such that travel time to openTTRVOP and travel time to close TTRVCL exceed the respective set values(tTrOpenAlm and tTrCloseAlm). The measured travel time for opening andclosing is shown on TTRVOP and TTRVCL respectively.4.3. Check that TRVTOPAL and TRVTCLAL are activated.5. Test of CB status1MRK 502 073-UUS A Section 13Testing functionality by secondary injectionGenerator protection REG670 2.2 ANSI and Injection equipment REX060, REX061, REX062 275Commissioning manual
