ABB Relion RES670 Operator's Manual

Also see for Relion RES670: Commissioning manual Product guide Installation manual Applications manual Product guide

Contents

ABB Relion RES670 Operator's Manual Manual pdf 16 page image

manual should be used as a technical reference during the engineering phase,installation and commissioning phase, and during normal service.The Installation and Commissioning Manual (ICM) contains instructions onhow to install and commission the protection IED. The manual can also be used asa reference during periodic testing. The manual covers procedures for mechanicaland electrical installation, energizing and checking of external circuitry, setting andconfiguration as well as verifying settings and performing directional tests. Thechapters are organized in the chronological order (indicated by chapter/sectionnumbers) in which the protection IED should be installed and commissioned.The Operator’s Manual (OM) contains instructions on how to operate theprotection IED during normal service once it has been commissioned. Theoperator’s manual can be used to find out how to handle disturbances or how toview calculated and measured network data in order to determine the cause of a fault.The Engineering Manual (EM) contains instructions on how to engineer the IEDsusing the different tools in PCM600. The manual provides instructions on how toset up a PCM600 project and insert IEDs to the project structure. The manual alsorecommends a sequence for engineering of protection and control functions, LHMIfunctions as well as communication engineering for IEC 61850 and DNP3.1.1.2 About the operator’s manualUse the operator’s manual for instruction on how to perform common tasks duringnormal service.The operator’s manual contains the following chapters:• The chapter “Safety information” presents warnings and notices, which theuser should pay attention to.• The chapter “Overview” describes operations an operator may perform on adaily basis or when the need arises.• The chapter “Understand the local human-machine interface” describes howto use the human-machine interface.• The chapter “Understand the HMI tree” describes the different menu trees.• The chapter “Read measured values” describes how to locate and identifyavailable measurement data.• The chapter “Event list” describes the location and nature of recorded events.• The chapter “Handle disturbances” describes how to retrieve disturbanceinformation and reset alarms.• The chapter “Read and change settings” describes how to locate, and changesettings and parameters.• The chapter “Diagnose IED status” describes the location and use of availablediagnostic tools.• The chapter “Test the IED” describes the tests applicable to the IED.• The chapter “Control and supervise the bay” describes how to use the SingleLine Diagram to open and close primary apparatuses.Section 1 1MRK511251-UEN BIntroduction10Operator's manual