ADJ Vizi BSW 300 User Instructions

Also see for Vizi BSW 300: User instructions

Contents

ADJ Products, LLC - www.adj.com - Vizi BSW 300 Instruction Manual Page 25ADJ Products, LLC - www.adj.com - Vizi BSW 300 Instruction Manual Page 24Vizi BSW 300 System MenuSystem Menu: When making adjustments press ENTER toconfirm your setup then press and hold the MENU buttonfor at least 3 seconds. To exit without making any adjust-ments press the MENU button. The display will lock after 30seconds, press the MENU button for 3 seconds to unlock.DMX SETTINGS -DMX Address - With this function, you can adjust the desired DMX-address via the Control Board.1. Access the main menu, and press the UP or DOWN buttons sothat “DMX Setting” is highlighted, then press ENTER.2. Press the UP or DOWN buttons until “DMX Address” is displayed,and press ENTER. The current DMX address will now be displayed.3. Use the UP or DOWN buttons to adjust the DMX address.4. Press ENTER to confirm or press MENU button to return to themain menu.DMX Channel Mode - With this function, you can select your desiredDMX channel mode.1. Access the main menu, and press the UP or DOWN buttons sothat “DMX Setting” is highlighted, then press ENTER.2. Press the UP or DOWN buttons until “DMX Channel Mode” is dis-played, and press ENTER. The current DMX channel mode will nowbe displayed.3. Press the MENU button to return to the main menu.DMX State - This mode can be used as a precaution mode, thatin case the DMX signal is lost, interrupted, or power is lost, theoperating mode chosen in this setup is the running mode thefixture will go into when the DMX signal is lost. You can alsoset this as the running mode you would like the unit to return towhen power is applied.1. Access the main menu, and press the UP or DOWN buttons sothat “DMX Setting” is highlighted, then press ENTER.2. Press the UP or DOWN buttons until “DMX State” is displayed,and press ENTER. Use the UP and DOWN buttons to switch betweenthe two modes; Blackout or Hold. Press the ENTER button to makeyour selection.• LAST STATE - If the DMX signal is lost the fixture will stay in thelast DMX setting. If power is applied and this mode is set, the unit willautomatically go into the last DMX set up.• BLACKOUT - If the DMX signal is lost or interrupted, the unit willautomatically go into stand by mode.• MASTER/SLAVE - If the DMX signal is lost or power is applied, theunit will automatically go into Master Slave mode and run a built-inshow.3. Press the MENU button to return to the main menu.SHOW SETTINGS -Show Mode - Select a desired preset show to run.1. Access the main menu, and press the UP or DOWN buttons sothat “Show Setting” is highlighted, then press ENTER.2. Press the UP or DOWN buttons until “Show Mode” is displayed,and press ENTER. The current setting will now be displayed.3. Use the UP or DOWN buttons to find your desired show. Shows1-4 are factory shows, while Show 0 is a random show.4. Press ENTER to confirm your selection or press the MENU buttonto return to the main menu.Slave Mode - Use this mode to set the unit as a “Master”, “Slave 1”or “Slave 2”1. Access the main menu, and press the UP or DOWN buttons sothat “Show Setting” is highlighted, then press ENTER.2. Press the UP or DOWN buttons until “Slave Mode” is displayed,and press ENTER. The current setting will now be displayed.3. Use the UP or DOWN buttons to find your desired setting. Select-ing “Slave 2” will give the unit contrast movement to the “Master”:Vizi BSW 300 System Menu