Physical Description NetVanta 6310/6330 Series Hardware Installation Guide18 Copyright © 2013 ADTRAN, Inc. 61700100G1-34FNetVanta 6330 Series Front Panel DesignThe NetVanta 6330 front panel is shown below. Table 1 on page 19 describes all of the LEDs.NetVanta 6330 Front Panel FeaturesStatus LEDsThe status LEDs are located on the lower left side of the unit. The STAT LED indicates the unit’sstatus. The FXO LED reflects the status of the FXO interfaces. The FXS LED reflects the status of theFXS interfaces. The SLOT 1 LED reflects the status of a NIM2/VIM2 installed in NIM2/VIM2 optionSLOT 1 (located on the rear panel). The LAN 1 and LAN 2 LEDs reflect the status of the local areanetworks (LANs).CompactFlash SlotThe CompactFlash slot supplies nonvolatile configuration and compressed code storage. CompactFlashdensities from 64 to 1024 MB are supported.Figure 3. NetVanta 6330 Series Front Panel LayoutNetVanta 6330 Rear Panel DesignThe NetVanta 6330 rear panel is shown below.Figure 4. NetVanta 6330 Series Rear Panel LayoutNetVanta 6330 Rear Panel InterfacesVOICE ConnectorA single 50-pin female amphenol connector labeled VOICE provides the interconnect wiring for up to24 analog ports. See Table A-5 on page 44 for the VOICE connector pinouts.NIM2/VIM2 Option SlotThe NIM2/VIM2 option slot (labeled SLOT 1) accepts a variety of NIM2/VIM2 option modules (referto Option Modules on page 23).FXO PortsThe two FXO interfaces (labeled FXO 0/1 and 0/2) provide FXO connectivity. See Table A-4 on page44 for the FXO connector pinouts.STATUSFXOFXSSLOT 1LAN 1LAN 2NetVanta 6330CompactFlashFXO0/1 0/2SLOT 1VOICEETH 0/1ETH 0/2100-240 VAC50/60 Hz