NetVanta 6310/6330 Series Hardware Installation Guide Unit Installation61700100G1-34F Copyright © 2013 ADTRAN, Inc. 39Figure 18. Wallmount Installation• To avoid damaging the unit, use only the screws included in the shipment whenattaching mounting ears to the chassis.• When wall mounting the NetVanta, care must be taken not to damage the power cord.Do not attach the power cord to the building surface or run it through walls, ceilings.floors, or openings in the building structure.• The socket-outlet must be installed near the equipment and must be easily accessible.Instructions for Wall Mounting the NetVantaStep Action1 Remove the mounting ears. Rotate them 90 degrees so that the portion of the bracket with themounting holes is flush with the bottom of the chassis. Reattach the mounting ears to thechassis (see Figure 18).2 Decide on a location for the NetVanta, keeping in mind that the unit needs to be mounted at orbelow eye-level so that the LEDs are viewable. The NetVanta 6310 can only be wall mountedwith the front panel facing to the right (see Figure 18).3 Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick)to a wall stud using #6 to #10 (2.5-inch or greater in length) wood screws.Important! Mounting to a stud ensures stability. Using sheetrock anchors may not providesufficient long-term stability.4 Have an assistant hold the unit in position as you install two #6 to #10 (1-inch or greater inlength) wood screws through the unit’s brackets and into the mounted board (see Figure 18).5 Proceed to the steps given in Supplying Power to the Unit on page 40.PRI 0/1SLOT 2SLOT 1ETH 0/1ETH 0/2PRI 0/1SLOT 2SLOT 1ETH 0/1ETH 0/2