NetVanta 6310/6330 Series Hardware Installation Guide Unit Installation61700100G1-34F Copyright © 2013 ADTRAN, Inc. 375. UNIT INSTALLATIONThe instructions and guidelines provided in this section cover hardware installation topics, such as mountingoptions, supplying power to the unit, and installing option cards. These instructions are presented as follows:• Tools Required on page 37• Mounting Options on page 38• Supplying Power to the Unit on page 40For information on configuring a specific application, refer to the configuration guides provided on theADTRAN’s Support Forum or the AOS Command Reference Guide.Tools RequiredThe customer-provided tools required for the hardware installation of the NetVanta are:• Ethernet cables• Network cables (module dependent)• Phillips-head screwdriver (rackmount applications only)• Drill and drill bit set (wallmount applications only)To prevent electrical shock, do not install equipment in a wet location or during alightning storm.• The NetVanta 6310/6330 Series is intended to be installed, maintained, and serviced byqualified service personnel only and should be installed in a restricted access locationas described in UL/IEC 60950-1.• Ethernet cables are intended for intrabuilding use only. Connecting an ADTRAN unitdirectly to Ethernet cables that run outside the building in which the unit is housed willvoid the user's warranty and could create a fire or shock hazard. To connect anADTRAN unit to Ethernet cables that run outside the building, ADTRAN's EthernetPort Protection Device (EPPD) (P/N 1700502G1) must be connected between the unitand the outside plant cable. Use of any Ethernet protector other than ADTRAN's for thispurpose will void the user's warranty.Electronic modules can be damaged by static electrical discharge. Before handlingmodules, put on an antistatic discharge wrist strap to prevent damage to electricalcomponents. Place modules in antistatic packing material when transporting or storing.When working on modules, always place them on an approved antistatic mat that iselectrically grounded.To access the CLI of the NetVanta, you will also need a PC with terminal emulationsoftware and a console port cable. Instructions on how to access the CLI are available inthe quick start guide shipped with your unit or online at ADTRAN’s Support Forum.