Control Port Operation HDSL2 for General Distribution Installation and Maintenance Practice30 61223HDSL2L2-5BOption 4, Enter Test Timeout from the BERT Test Screen displays the Timeout Screen (Figure28). The time out can run for a specific duration by entering the hours and/or minutes, or canrun indefinitely by entering 00:00, as indicated by the note on the screen. With no testrunning the Toggle Test Direction option from the BERT Test Screen allows the toggling of thetest signal in the opposite direction (from customer to network and vice versa).Figure 28. BERT Test Functions - Enter Test Timeout OptionWhen option 1, (Re)start Pattern is selected to start the test, option 5 changes to Inject BitErrors. This option is used to display the screen shown in Figure 29. This allows the insertionof errors from this test origination point to validate the test results.Figure 29. BERT Inject Errors ScreenShelf: 1 Slot: 18 Total Access System 03/01/05 09:29Unacknowledged Alarms: NoneCircuit ID:CUSTOMER Timeout ScreenTest Timeout(Hr:Min) = 02:00----------------------------1. Change Timeout*NOTE: When timeout is set to 00:00, thetest will run indefinitely.Selection:Shelf: 1 Slot: 14 Total Access System 03/01/05 09:29Unacknowledged Alarms: NoneCircuit ID:BERT Test ScreenTest Results----------------------------------------------------Test Direction: CustomerUnframed Pattern Generation: ONPattern: 2^23 PatternLine Coding: B8ZSBit Errors: 0000000Bit Error Rate: 0.0E-05Pattern Sync: ACQUIREDPattern Sync Losses: 000Test Length (HH:MM:SS): 02:00:00Time Elapsed (HH:MM:SS): 00:02:32----------------------------------------------------1. Number of Errors to Inject = 001 (Maximum=255)2. Inject Bit Error3. (Re)startSelection:
