Chapter 5: Configuration61202.086L1-1 ISU 512 User Manual 31Figure 5-2Dial Options MenuFront PanelTo establish and disconnect calls using the front panel, configure Dial optionsfor Front Panel. See the section Front Panel for more details.RS-366To establish and disconnect calls using the RS-366 parallel dialing port, config-ure the unit for RS-366 dialing. This enables the RS-366 port on the rear of theunit. An RS-366 Y cable (part number 1200120L1) is available for dual RS-366applications such as videoconferencing. DTE RS-366 dialers can end a stringof dialed numbers by sending the end of number (EON) to alert the ISU 512that the entire number has been sent. Another method is to stop sending num-bers and allow the ISU to time out, then dial the number. Use the followingoptions to fine-tune the dialed number termination:1 sec or EONThe ISU 512 assumes the dial string is fully entered if more than 1 secondelapses since input of the last digit, or the unit receives the EON command.2 sec or EONThe ISU 512 assumes the dial string is fully entered if more than 2 secondselapse since input of the last digit, or the unit receives the EON command.3=CONFIG1=Netw. options2=DTE options3=BONDING setup4=Quick setup1=Dial Line2=Leased Line1=Switch type2=Call type3=Terminal ID4=Dial options5=Auto answer6=Connect Timout7=Call Screening8=Passwords9=Maint Setup1=1 sec or EON2=2 sec or EON3=5 sec(default)4=10 sec or EON5=20 sec or EON6=Wait for EON1=Front Panel2=RS-3663=V.25 1=HDLC2=HDLC(FLAGS)1=enabled2=disabled1=RS366 Time2=Security0=Call NumID
