Problem Possible cause RemedyThe oven does not heat up. The fuse is released. Make sure that the fuse isthe cause of the malfunction.If the fuse releases againand again, contact a quali-fied electrician.The lamp does not operate. The lamp is defective. Replace the lamp.The display shows F111. The plug of the core tem-perature sensor is not cor-rectly installed into the sock-et.Put the plug of the core tem-perature sensor as far aspossible into the socket.The display shows an errorcode that is not in this table.There is an electrical fault. • Deactivate the oven withthe house fuse or thesafety switch in the fusebox and activate it again.• If the display shows theerror code again, contactthe Customer Care De-partment.Steam and condensationsettle on the food and in thecavity of the oven.You left the dish in the ovenfor too long.Do not leave the dishes inthe oven for longer than 15 -20 minutes after the cookingprocess ends.14.2 Service dataIf you cannot find a solution to theproblem yourself, contact your dealer oran Authorised Service Centre.The necessary data for the service centreis on the rating plate. The rating plate ison the front frame of the appliancecavity. Do not remove the rating platefrom the appliance cavity.We recommend that you write the data here:Model (MOD.) .........................................Product number (PNC) .........................................Serial number (S.N.) .........................................15. WARRANTYFOR SALES IN AUSTRALIA AND NEWZEALANDALL AEG BRANDED APPLIANCESThis document sets out the terms andconditions of the product warrantiesfor AEG Appliances. It is an importantdocument. Please keep it with yourproof of purchase documents in a safeplace for future reference should yourequire service for your Appliance.ENGLISH 45