Team Functions Programming the Call Keys914.2.2 MenuCard “Team Key”g Long press the team key for a moment, then select …1 Modify text: The text currently assigned to the key is shown on the displayof your telephone. To change the text, press O. Delete the existing text withthe C key and enter new text, if required. Press O and confirm this withSave. If you delete the text without entering any new text, only the key’s tele-phone number will be displayed.2 Call signalling: Specify whether call signalling to this key is to beOptical & acoustic, Optical only or Acoustic after delay. If you selectAcoustic after delay, specify the number of seconds after which your tele-phone is to ring.3 Call protect: Switch call protection On or Off for all calls, for internal callsonly, or for external calls only. If call protection has been activated, this team keywill only indicate calls by means of a visual signal, even if they are made from adirect-call key.4 Ring tone: You can set the Volume and Melody for each team key. Proceedas described in the section entitled MenuCard “Phone Settings” starting onpage 107.5ƒCall wait. prot.: While you are making a call, other calls for the telephonenumber of this team key are not signalled by a call-waiting tone (but at the teamkeys of other terminals unless call-waiting protection was programmed there).4.2.3 MenuCard “Busy Key”g Long press the busy key, then select …1 Modify text: The text currently assigned to the key is shown on the displayof your telephone. To change the text, press O. Delete the existing text withthe C key and enter new text, if required. Press O and confirm this withSave. If you delete the text without entering any new text, only the key’s tele-phone number will be displayed.