Configuring the Switch3-1163Web – Click VLAN, 802.1Q VLAN, Static List. To create a new VLAN, enter theVLAN ID and VLAN name, mark the Enable checkbox to activate the VLAN, andthen click Add.Figure 3-64. VLAN Static List - Creating VLANsCLI – This example creates a new VLAN.Adding Static Members to VLANs (VLAN Index)Use the VLAN Static Table to configure port members for the selected VLAN index.Assign ports as tagged if they are connected to 802.1Q VLAN compliant devices, oruntagged they are not connected to any VLAN-aware devices. Or configure a portas forbidden to prevent the switch from automatically adding it to a VLAN via theGVRP protocol.Notes: 1. You can also use the VLAN Static Membership by Port page to configureVLAN groups based on the port index (page 3-118). However, note that thisconfiguration page can only add ports to a VLAN as tagged members.2. VLAN 1 is the default untagged VLAN containing all ports on the switch, andcan only be modified by first reassigning the default port VLAN ID asdescribed under “Configuring VLAN Behavior for Interfaces” on page 3-119.Console(config)#vlan database 4-173Console(config-vlan)#vlan 2 name R&D media ethernet state active 4-174Console(config-vlan)#endConsole#show vlan 4-181VLAN Type Name Status Ports/Channel groups---- ------- ---------------- --------- ----------------------------------1 Static DefaultVlan Active Eth1/ 1 Eth1/ 22 Static R&D Active Eth1/ 3 Eth1/ 43 Static Active Eth1/ 5 Eth1/ 64 Static Active Eth1/ 7 Eth1/ 85 Static Active Eth1/ 9 Eth1/106 Static Active Eth1/11 Eth1/127 Static Active Eth1/13 Eth1/148 Static Active Eth1/15 Eth1/16...Console(config-vlan)#
