Command Line Interface4-1304ExampleThe following example enables flow control on port 5.Related Commandsnegotiation (4-127)capabilities (flowcontrol, symmetric) (4-128)combo-forced-modeThis command forces the port type selected for combination ports 21-24/45-48. Usethe no form to restore the default mode.Syntaxcombo-forced-mode modeno combo-forced-mode• mode- copper-forced - Always uses the built-in RJ-45 port.- copper-preferred-auto - Uses the built-in RJ-45 port if both combinationtypes are functioning and the RJ-45 port has a valid link.- sfp-forced - Always uses the SFP port (even if module not installed).- sfp-preferred-auto - Uses SFP port if both combination types arefunctioning and the SFP port has a valid link.Default Settingsfp-preferred-autoCommand ModeInterface Configuration (Ethernet)ExampleThis forces the switch to use the built-in RJ-45 port for the combination port 48.shutdownThis command disables an interface. To restart a disabled interface, use the noform.Syntax[no] shutdownConsole(config)#interface ethernet 1/5Console(config-if)#flowcontrolConsole(config-if)#no negotiationConsole(config-if)#Console(config)#interface ethernet 1/48Console(config-if)#combo-forced-mode copper-forcedConsole(config-if)#
