Flash/File Commands4-674ExampleThe following example shows how to display all file information:whichbootThis command displays which files were booted when the system powered up.Default SettingNoneCommand ModePrivileged ExecExampleThis example shows the information displayed by the whichboot command. Seethe table under the dir command for a description of the file information displayed bythis command.boot systemThis command specifies the image used to start up the system.Syntaxboot system {boot-rom| config | opcode}: filenameThe type of file or image to set as a default includes:• boot-rom* - Boot ROM.• config* - Configuration file.• opcode* - Run-time operation code.• filename - Name of the configuration file or image name.* The colon (:) is required.Console#dirfile name file type startup size (byte)-------------------------------- -------------- ------- -----------Unit1:Diag.bix Boot-Rom image Y 818812V11022 Operation Code Y 2402452Factory_Default_Config.cfg Config File N 374startup Config File Y 7606-------------------------------------------------------------------Total free space: 3932160Console#Console#whichbootfile name file type startup size (byte)-------------------------------- -------------- ------- -----------Unit1:Diag.bix Boot-Rom image Y 818812V11022 Operation Code Y 2402452startup Config File Y 7606Console#
