1755.Press and hold the left and right Slide Extension Release Leversand slowly slide the component throughout its entire range ofmotion to ensure that cabling is not strained or restrictingmovement of Slide Rails. Make certain cabling is not pinched whenslides and CMA are in the fully retracted position.General Safety InformationWARNING! WARNING statements indicate a possible hazardwhich, if not avoided, could result in personal injury or death.Caution! Caution statements indicate a problem or unsafe practicewhich, if not avoided, could result in product or property damage.Note: Note statements provide supplemental information.WARNING !• For complete safety and regulatory information, see yourSystem Information document.• This Slide Rail kit is intended only for use with components of1 RU or 2 RU height.• Maximum component weight: 18.2 kg (40 lb.) for 1 RU; 38.6 kg(85 lb.) for 2 RU.• Installing components in a rack without the front and sidestabilizers could cause the rack to tip over. Always install thestabilizers before installing components in the rack.• Always load the rack from the bottom up. Load the heaviestcomponent in the rack first in the lowest position.• When preparing to install a component in the rack, alwaysextend the Slide Rails into the locking position, and then slidethe component into the Slide Rail mounting positions.• Use caution when pressing the Slide Rail release latches andsliding the component in or out of the rack; the Slide Rails canpinch your fingers.
