4 Configuring the system52Removing a Floppy Drive from the ConvertedHard Drive Bay1.Power down the server and unplug all peripheral devices and the ACpower cable.2.Remove the chassis cover.3.Remove the front bezel if it is installed.4.Open the connector labeled "Floppy Con" on the backplane bypulling up on the connector cover. Remove the flat flex cable from thebackplane.5.Push in on the lever at the rear of the floppy carrier and slide thedrive from the front of the chassis.6.Open the connector cover on the rear of the floppy drive by pullingup on it. Release the flat flex cable from the drive.7.Remove the two screws at each side that hold the drive rails to thedrive carrier. Lift the two rails from the carrier.8.Disconnect the two screws attaching the drive to the converted harddrive bay carrier.9.Install an empty hot-swap hard drive carrier into chassis drive bay ifno floppy or hard drive is to be installed into the bay.10.Store the screws, the converted drive bay carrier, the side rails, andthe flat flex cable for future use.11.Install the chassis cover.12.(Optional) Install the front bezel.13.Plug all peripheral devices and the AC power cable back into theserver.
