Advanced Bionics Platinum Series User Manual
Also see for Platinum Series: User guideTroubleshooting guide
                                        | |
Contents
| 
User Guide for the Platinum Series Sound Processor 27Troubleshooting GuideThe following is a description of the most common problems you may encounter withyour processor and solutions for addressing those problems. After trying the remediesbelow, if the problem persists, contact your programming center or AB for support.No Sound Heard; No Response From User• Ensure that the cable is inserted into the processor and the headpiece isproperly positioned. Turn the processor off (o) and back to position , , or .• If the red LED indicator:- Does not blink or blinks once, replace the lithium ion battery or batterycompartment with another fully-charged lithium ion battery or new AAbatteries.- Blinks quickly 2 to 4 times and then flashes continuously, replace thecable first and then headpiece if flashing continues.- Blinks quickly 2 to 4 times, followed by 1 flash, no sounds are heard,replace the headpiece. If a headpiece is not available, use the auxiliarymicrophone with a program that is set up to allow auxiliary input andrepeat the process.- Blinks quickly 2 to 4 times, followed by 1 flash, green LEDilluminates in response to loud speech at the site of the microphone,and sounds are heard, the system is functioning properly.User Hears Static• Ensure that the sensitivity control is properly set (12:00 position).• Replace the cable.• Check and clean battery contacts.User Hears Muffled or Distorted Sounds• Ensure that the sensitivity control is properly set (12:00 position).• Ensure that nothing is covering the headpiece microphone opening.• Check and clean battery contacts.• Use the green LED, auxiliary microphone or microphone tester earphones todetermine if a new microphone is needed for the headpiece. |
Related manuals for Advanced Bionics Platinum Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine