22 PCM-5864/E/L User's Manual2.8.1 Connecting the hard driveConnecting drives is done in a daisy-chain fashion. It requires oneof two cables (not included in this package), depending on thedrive size. 1.8" and 2.5" drives need a 1 x 44-pin to 2 x 44-pin flat-cable connector. 3.5" drives use a 1 x 44-pin to 2 x 40-pinconnector.Wire number 1 on the cable is red or blue, and the other wires aregray.1. Connect one end of the cable to CN12. Make sure that the red(or blue) wire corresponds to pin 1 on the connector, which islabeled on the board (on the right side).2. Plug the other end of the cable into the Enhanced IDE harddrive, with pin 1 on the cable corresponding to pin 1 on thehard drive. (See your hard drive’s documentation for thelocation of the connector.)Connect a second drive as described above.Unlike floppy drives, IDE hard drives can connect to either end ofthe cable. If you install two drives, you will need to set one as themaster and one as the slave by using jumpers on the drives. If youinstall just one drive, set it as the master.2.8.2 CompactFlash (CN501)The CompactFlash card shares an IDE channel which can beenabled/disabled via J13.Table 2-10: Comp actFl ash en able/disable (J13)Enabled DisabledJ13
