34 PCM-5864/E/L User's Manual2.18.6 LCD backlight signal setting (J8)The backlight signal can either choose positive enable or negativeenable when using the J8 setting.Table 2-20: L CD bac klight signal setting (J8)Positive signal Negative signalJ8Configuration of the VGA interface is done completely via thesoftware utility. You do not have to set any jumpers. Refer toChapter 3 for software setup details.Refer to Chapter 3 for details on connecting the five standardLCDs: Sharp LM64183P, LM64P89, Toshiba LTM10C042, Sharp64C142, and Planar EL display.2.19 Ethernet configurationThe PCM-5864/E/L is equipped with a high performance 32-bitPCI-bus Ethernet interface which is fully compliant with IEEE802.3U 10/100Mbps CSMA/CD standards. It is supported by allmajor network operating systems.The medium type can be configured via the RSET8139.EXEprogram included on the utility disk. (See Chapter 3 for detailedinformation.)2.19.1 100Base-T connector (CN3)100Base-T connects to the PCM-5864/E/L via an adapter cable toa 10-pin polarized header (CN3). For 10Base-T RJ-45 operation,an adapter cable converting CN3 into a standard RJ-45 jack isrequired.123123