82 PCM-5864/E/L User's Manual8.1 IntroductionThe PCM-5864/E/L is equipped with a high-performance 32-bitEthernet chipset which is fully compliant with IEEE 802.3 100Mbps CSMA/CD standards. It is supported by major networkoperating systems. It is also both 100Base-T and 10Base-Tcompatible. The medium type can be configured via the82558.exe program included on the utility disk.The Ethernet port provides a standard RJ-45 jack. The networkboot feature can be utilized by incorporating the boot ROM imagefiles for the appropriate network operating system. The boot ROMBIOS files are combined with system BIOS, which can beenabled/disabled in the BIOS setup.8.2 Installation of Ethernet driverBefore installing the Ethernet driver, note the procedures below.You must know which operating system you are using in yourPCM-5864/E/L, and then refer to the corresponding installationflow chart. Then just follow the steps described in the flow chart.You will quickly and successfully complete the installation, evenif you are not familiar with instructions for MS-DOS orWINDOWS.Note: The windows illustrations in this chapter areexamples only. You must follow the flow chartinstructions and pay attention to the instructionswhich then appear on your screen.8.2.1 Installation for MS-DOS and Windows 3.1If you want to set up your Ethernet connection under the MS-DOSor Windows 3.1 environment, you should first check your serversystem model. For example, MS-NT, IBM-LAN server, and so on.Then choose the correct driver to install in your panel PC.The installation procedures for various servers can be found onCD-ROM. The file path begins as:
