Section 2: Basic InstallationAXIS 570/670 MIO User’s Manual 19Connecting the AXIS 670 MIO to the Token Ring NetworkCaution DO NOT connect or disconnect the network cabling while the AXIS670 MIO is powered on, otherwise the equipment maybe damaged.1. Switch off the printer.2. Connect an STP (Media Type 1) or UTP (Media Type 3) cable tothe AXIS 670 MIO.3. Switch on the printer.4. Successful connection of the AXIS 670 MIO to you network willbe confirmed by the intermittent flashing of the NetworkIndicator.5. You are now ready to install your server onto your network usingone of the methods detailed in the Installation Guide, on page 20.By commencing with your preferred installation method, you canfurther very that your AXIS 670 MIO is properly connected toyour network.Notes: o To minimise signal noise it is recommended that you use screenedor foiled Media Type 3 cabling for 16 Mbit networks and notstandard UTP cabling.o Each AXIS 670 MIO Print Server is pre-configured with a uniqueNode Address that is identical to the serial number. This can bechanged using the AXIS NetPilot™, the Front Panel of theprinter or any standard Web browser using HTTP, if required.AXIS670 MIO
