Section 5: Setting Up - WindowsAXIS 570/670 MIO User’s Manual 81WindowsSection 5 Setting Up - WindowsThis section describes how to set up your AXIS 570/670 MIO forprinting in the Windows environment, after it has been connected toyour network.The following Windows platforms are supported:• Windows 3.1 (requires add-on network support, see page 83)• Windows for Workgroups• Windows 95• Windows NTIf you intend to use the AXIS 570/670 MIO in a multiprotocolenvironment, you should also proceed to other relevant sections in thismanual, namely:Section 3 Setting Up - SNASection 4 Setting Up - NetWareSection 6 Setting Up - OS/2Section 7 Setting Up - MacintoshSection 8 Setting Up - UNIXSection 9 Web Based ManagementInstallation Using AXIS Print Utility for WindowsUnless you wish to change the default name of yourAXIS 570/670 MIO, the setup operation may be performed solelywith the AXIS Print Utility for Windows, which is supplied on theAXIS Utilities disk. You should install this utility now if you have notalready done so - see the instructions on the AXIS Utilities disk label.If you wish, you may change the default name of yourAXIS 570/670 MIO or amend any of the default parameters, using theAXIS NetPilot™, or any standard Web browser. Refer to Section 9 -Web Based Management.SNA
