Axis P1357-E User Manual

Also see for AXIS P1357-E: User manual User manual User manual Installation guide Installation guide

AXIS P1357-E Network CameraHow to access the productAbout the AXIS Media Control viewer toolbarThe AXIS Media Control viewer toolbar is available in Internet Explorer only. See About AXIS Media Control (AMC) on page 15 formore information. The toolbar displays the following buttons:The Play button connects to the Axis product and starts playing a media stream.The Stop button stops the media stream.The Snapshot button takes a snapshot of the video image.Click the View Full Screen button and the video image will fill the entire screen. Press ESC (Escape) on the computerkeyboard to cancel full screen view.The Record button is used to record the current video stream on your computer. The location where the recording is savedcan be specified in the AMC Control Panel. Enable this button from Live View Config > Viewer Settings.AMC Audio ControlsAMC audio buttons control the speakers and microphone connected to the client computer. The buttons are only visible whenaudio is enabled.For information about how to configure audio, see How to change audio settings on page 28.Speaker button — Click to turn the speakers on or off.Microphone button – Click to mute or unmute the microphone. In Simplex - speaker only mode, the Microphone and Talkbuttons must both be active to send audio to the Axis product. Click either button to stop audio transmission.Use the slider to control the volume of the speakers and the microphone.Half-duplex modeThe Talk/Listen button is used to switch between sending and receiving audio. The button can be configuredfrom the Audio tab in the AMC Control panel:• Push-To-Talk mode: Click and hold the button to talk/send. Release the button to listen.• Toggle mode: Click once to switch between talking and listening.Simplex – speaker only modeTo send audio, the Talk and Microphone buttons must both be active. Click either button to stop audiotransmission.PTZ ControlsNoteThese controls are available if digital PTZ is enabled in the selected view area or if a PTZ driver has been uploaded. For moreinformation on view areas, see View Area on page 24. For more information on how to upload a driver, see How to install aPTZ driver on page 35. To switch between the two options see PTZ Mode on page 11.With the PTZ Control Queue enabled the time each user is in control of the PTZ settings is limited. Click the buttons to request orrelease control of the PTZ controls. The PTZ Control Queue is set up under PTZ > Control Queue.13