BAFANG DP C07.UART Manual

Also see for BT C01.340.UART: Customer's manual Manual Customer's manual

Contents

BAFANG DP C07.UART Manual Manual pdf 10 page image

CONSUMER MANUAL MAX DRIVE SYSTEM CONSUMER MANUAL MAX DRIVE SYSTEMDISPLAY (DP CO7.UART)16 171.5.7 Automatic Off TimeWhen the speed field displays OFF, press / tochoose a figure between 1 and 9. The gures indicatethe minutes that it takes to automatically shut downthe display.After this setting, briefly press (< 0.3 seconds) toenter the setting interface of maintenance warning.1.5.8 Maintenance Warning(can be deactivated)When the speed field displays nnA, press / tochoose either 0 or 1. 0 disables the function while 1enables it.After this setting, briefly press (< 0.3 seconds) toenter the setting interface of password input.Maintenance Warning SettingThe display will prompt maintenance necessity basedon such information as the accumulated riding dis-tance and the battery charge cycles.• When the accumulated total riding distanceexceeds 5,000 km (can be customized by themanufacturer), the display will show the symbol. When the display is started up, thesign for accumulated riding distance will flashfor 4 seconds, indicating that maintenance isnecessary.• When the number of battery charge cycles ex-ceeds 100 (can be customized by the manufactu-rer), the display will the symbol . Whenthe display is started up, the sign for battery willflash for 4 seconds, indicating that maintenanceis necessary.• The maintenance alert function can be disabled:settings maintenance alert (MA) main-tenance alert (MA) 0. (Maintenance alertcan also be set via a computer. This requires aUSB connection. See also the parameter settinginstructions).1.6 Error Code DefinitionsThe MAX-C966 display can show e-bike faults. When a fault is detected, the icon will be displayed. In the speedfield one of the following error codes will be displayed:Error Code Error Description Error-shooting Method“03” Brake enabled Check whether a brake cable is stuck“04” The throttle has not returned home Check if throttle has returned home“05” Throttle fault Check the throttle“06” Low voltage protection Check the battery voltage“07” Overvoltage protection Check the battery voltage“08” Motor hall signal cable fault Check the motor module“11” Controller temperature sensor failure Check the controller“12” Current sensor failure Check the controller“13” Battery temperature fault Check the battery“21” Speed sensor fault Check installation position of speed sensor“22” BMS communication fault Replace the battery“30” Communication fault Check the controller connectionError display“10” Stop the bicycle until the error code “10”disappears from the screenNote: Error Code 10 will probably appear on the dispalywhen the e-bike is climbling for a long time. Thisindicates that the motor temperature has reached theprotection value, in which case the user needs to stopthe e-bike for a rest. If the user continues to run thee-bike, the motor will automatically cut off the power.The motor temperature has reachedthe threshold