BAFANG DP C07.UART Manual

Also see for BT C01.340.UART: Customer's manual Manual Customer's manual

Contents

BAFANG DP C07.UART Manual Manual pdf 13 page image

BATTERIESChargerThe charger is specially designed for charginglithium-ion batteries. It is equipped with an inte-grated fuse and protection against overcharging.Keep the charger away from child ren andanimals. Small children and animals maydamage the cable while playing.This can leadto an electric shock, a malfunction or a fire.• The charger must not be used by children, orby persons with limited physical, sensory ormental capabilities, unless under the supervi-sion of a responsible adult.• Make sure the charger is clean. There is arisk of electric shock.• Do not use your charger in humid or dustyplaces.• Avoid direct sunlight.• Disconnect the charger from the power sup-ply when not in use.• Only use the charger that came with yourpedelec or one from the same manufacturer.• Don’t cover the charger while it is in use. Itcould otherwise short circuit or cause a fire.• When you clean the charger, unplug it fromthe electrical socket first.• When charging takes longer than shown inthe specifications table, stop charging.• After charging, remove the battery from thecharger and unplug the charger.2.6 OPERATION2.6.1 Installing the batteryFor correct insertion, the battery must beinserted and locked from the rear of the casingas far as it will go. Without contact with thebattery, the electric drive of your pedelec willnot work.1.re inserting it intothe holder.2. For the battery to be inserted, the lock mustbe unlocked. You can lock and unlock thebattery by turning the key provided.3. Slide the battery along the rail track into theconnector on the rail as far as it will go, thenturn the key to lock the battery.Put the battery in its housing inside theframe and press the lower part towardsthe frame to lock.4. Remove the key to avoid losing or breaking it.2.6.2 Removing the batteryWhen removing the battery proceed as follows:1. Spossible, the battery.2. Unlock the battery.Pull out of rack3. Remove the battery from the casing/batteryholder.Hold the battery tightly as it is heavy.2.6.3 LED capacity and stateof charge indication• Press the button to wake up from Sleepmode• Hold down the button for 5 seconds towake up from Deep Sleep modeThen check the current charge level of your bat-tery by pressing the on/ y.The charge status is indicated by LEDs, which areilluminated ford rent charging states as listedin the following table.CONSUMER MANUAL MAX DRIVE SYSTEM CONSUMER MANUAL MAX DRIVE SYSTEM22 23