BAFANG DP C07.UART Manual

Also see for BT C01.340.UART: Customer's manual Manual Customer's manual

Contents

BAFANG DP C07.UART Manual Manual pdf 14 page image

BATTERIES2.7 Charging the batteryYou can charge your battery both whilemounted on the Pedelec and removed.Lithium-ion batteries are not subject to a memo-ry effect. You can recharge your battery at anytime, even after short trips.Charge your battery at temperatures between0 °C and 45 °C (ideally at room temperature or20 °C). Give the battery sufficient time beforecharging to reach this temperature.Read the instructions on the charger beforecharging.1. First insert the plug of the charging cableinto the charging socket on the battery, thenthe plug the charger into a socket.2. As soon as the charger is connected to thepower supply, a red LED will light up.redCharger with arrow and text "red LED"When charging is complete, the LED changesfrom red to green.greenCharger with arrow and text "green LED"Charging time depends on various factors. It canvary greatly according to the temperature, age,usage and capacity of the battery. You can findindications of possible charging times, if neces-sary, in the technical data of the battery.When the battery is fully charged, the chargingprocess is automatically terminated. Unplug theplug from the battery and the power outlet.Only use the charger designed for the battery.Make sure you use the correct mains voltage.The required mains voltage is indicated on thecharger. It must comply with the voltage of thecurrent source. Chargers marked 230V can alsobe operated at 220 V.• Do not touch the power plug with wethands. There is a risk of electric shock.• Before use, check that the charger, cableand plug are not damaged. If damage oc-curs, do not use the charger. There is a riskof electric shock.• Charge the battery in well-ventilated roomsonly.• Do not cover the charger and/or battery dur-ing charging. There is a risk of over-heating,fire, or explosion.• Only charge on a dry, non-flammablesurface.The battery has to be recharged completely atleast every 3 months, in order to avoiddamaging or destroying the cells.If the charging time exceeds the usual chargingtimes (see table), the battery may be damaged.In this case, immediately stop charging. Have adealer check the battery and charger to avoiddamage.Errors – Causes and SolutionsError description Cause SolutionThe operating display doesnot light upMains plug not properly con-nected to the power supplyCheck all connections and whetherthe charger is properly connected tothe power supplyThe charging indicator isnot lighting upThe battery may have amalfunctionContact the manufacturer or yourspecialist dealerThe charging indicator is notlighting up permanent redThe battery may have amalfunctionContact the manufacturer oryour specialist dealerCONSUMER MANUAL MAX DRIVE SYSTEM CONSUMER MANUAL MAX DRIVE SYSTEM24 25LED LED state SOC NOTESFirst LED flickers ≤ 5 % When the system is triggeredin operation mode: Press thebutton for 1 second for theBMS to display the charge ofthe battery on the LEDs for5 seconds. Hold down thebutton for 5 seconds for theBMS to display the capacity ofthe battery on the LEDs for 5seconds. After this, the BMSwill turn off the LED display tosave battery power.One green light 5 < C < 10 %Two green lights 10 ≤ C < 30 %Three green lights 30 ≤ C < 50 %Four green lights 50 ≤ C < 75 %Five green lights ≥ 75 %