BATTERIESO2.8 Switching the electricalsystem on and offMake sure that the pedals of your Pedelec arenot weighed down when the system is turnedon. Any load on the pedals as it is switched onmay lead to power restrictions and errormessages. When this happens, switch off thesystem and turn it on again.ConditionsIn order to activate and use your Pedelec, thefollowing prerequisites must be fulfilled:• A sufficiently charged battery must be used.• The battery must be inserted correctly intothe battery holder.• The motor, control unit, control unit/battery,etc. must all be connected correctly.You can switch the electrical system of your Pe-delec on and off according to the description onthe control unit, see section "Control element".If the battery of your Pedelec is equipped with anon/off switch, you can also press the switch onthe battery.Battery switch On-OffIf you press the switch again, the system will beturned off.2.9 Storing the batteryIf you do not use your Pedelec for an extendedperiod of time, remove the battery, charge it(60-80%) and store it separately in a frost-free,dry room.• Check the charge level every 3 months andrecharge if necessary.• Store your battery at a temperature between-10 °C and 35 °C.• Avoid storing in direct sunlight.• To prevent deep discharge, the battery willgo into sleep mode after a certain time.• Do not expose the battery to temperaturesbelow the permissible storage temperatureof -10 °C to 35 °C. Note that temperaturesof around 45 °C are common near heaters,in direct sunlight or in over-heated vehicleinteriors.If you notice the battery becoming hot duringuse, charging or storage, developing a strongodor, changing appearance, or any otherabnormality, do not continue to use the battery.Immediately stop using the battery and have adealer check it before you use it again.CONSUMER MANUAL MAX DRIVE SYSTEM CONSUMER MANUAL MAX DRIVE SYSTEM26 27