3 - 26Electrical parts and motorsMain unit4 Side feed mechanism attachment1. Attach the side feed unit 1 and wire clip using 2 screws 1.2. Attach the side feed adjust plate 2 to the feed module feed bar using 2screws 2.1 Torque1.47 – 1.96 N·m2 Torque0.79 – 1.18 N·m 12 12Taptite, Bind SM4X10Screw, BindM3X65 Assembly of main motor assembly1. Attach the fender rubber 1 to the motor holder 2.2. Engage the 2 spacers (4 x 6) 3 with the 2 round holes on the fender rubber1.3. Attach the main motor 4 and the motor spacer presser 5 to the motorholder 2 with the 2 screws 1.1 Torque1.18 – 1.57 N·m425113Screw, Pan (S/P washer)M4X146 Main motor assembly attachment1. Attach the timing belt 1 to the upper shaft timing pulley and the motorpulley, align the main motor assembly 2 with the arm bed and hand startthe 2 screws 1.(Fully tighten after 4 - 7 "Motor belt tension adjustment").1 TorqueHand tighten12 1Upset4X12DB7 Motor fan attachment1. Attach the motor fan 1 to the main motor assembly 2.*Key point• Be careful removing the motor fan 1 because the wings of thefan are very fragile.12