3 - 77Thread cutter moduleModulesAssembly1 C pulse motor attachment1. Attach the C pulse motor (ZPMM35SP-9N) 1 to the motor holder assy 2using the 2 screws 1.*Key point• Attach the band 3.2. Lubricate the C pulse motor 1 bearing with 1 – 2 drops ofturbine oil # 100.Lubricate the CPM bearing with FBK OIL RO 100. 1 – 2 dropsXC8388***1 Torque0.78 – 1.18 N·m1132Screw, BindM3X42 Idle gears A and B attachment1. Apply a small amount of EPNOC AP(N)0 to the idle gear shaft 1.2. Attach the idle gear A 2, spring 3 and idle gear B 4 to the idle gear shaft1, and attach the retaining ring E2.*Key point• Insert the spring 3 into the small holes 5 in the idle gear A 2and the idle gear B 4, and turn the idle gear A 2 clockwiseuntil the large holes 6 in the idle gear A 2 and the idle gear B4 overlap 7.• With the large holes 6 aligned, align the match mark 8 onthe idle gear assy and the match mark 9 on the C pulse motorgear ;, and attach the idle gear assy to the shaft 1.Apply EPNOC AP(N)0 to the lever guide shaft Small amountXC8387***2863 457 19Retaining ring E2;
