Selecting an Embroidery Pattern 169—————————————————————————————————————————————————————————————————————————————————————5■ If the desired pattern cannot be recalledWhen recalling pattern data from the computer,the data is not taken directly from the computer.Instead, the pattern data is temporarily written tothe machine, and that written pattern data isrecalled. A total of about 3 MB of embroiderypatterns can be saved in the “Removable Disk”.Pattern data cannot be recalled if that dataamount is exceeded.1 Shows the amount of free space in the USB areaof the machine. If pattern data with this size isadded, it can be recalled (temporarily written).To recall a pattern larger than the amount ofspace available, delete any currently writtenpatterns, and then place the pattern that youwish to recall into the folder.1Remove all unnecessary patterns from the“Removable Disk” folder on the computer.Select the pattern data, and then move it to adifferent folder, the Recycle Bin, or right-clickit and click “Delete”.2Place the pattern that you wish to recall intothe “Removable Disk” folder.X After writing the data to the embroiderymachine, the key for that pattern appearsin the screen.3If the desired pattern can still not be written,repeat steps 1 and 2.■ Disconnecting the USB cableBefore disconnecting the USB cable, click the“Unplug or Eject Hardware” icon in the taskbarof Windows 2000, the “Safely RemoveHardware” icon in the taskbar of Windows XP/Windows Vista or the “Safely Remove Hardwareand Eject Media” icon in the taskbar ofWindows 7. Then, when the removable disk cansafely be removed, disconnect the USB cablefrom the computer and the machine.In case of Windows 7In case of Windows VistaNote● Be sure to perform the operation describedabove before disconnecting the USB cablefrom the computer and embroiderymachine, otherwise the computer maymalfunction, the data may not be writtencorrectly, or the data or data writing areaon the embroidery machine may bedamaged.● Do not unplug a USB device/media fromthis machine immediately after it has beenplugged in. Be sure to wait at least 5seconds before unplugging the USBdevice/media.1
