BASIC SETTINGS AND HELP FEATURE ———————————————————————————————————————————————————————————224■ When using Tajima embroidery data (.dst)2 If “ON” is selected, touch and toselect the number of feed codes.The desired setting is displayed.• A value between 1 and 8 can be specified.For example, if 3 is specified, sequential 3jump codes will be converted to the trimcode. But sequential 2 jump codes will notbe converted to the trim code, it will besewed as the feed (jump) stitch.Note● You need to set the jump number same asthe number that was used when theparticular Tajima data was created.If the jump number is not matched, eitherunexpected trim or no trimming at trimexpected point will happen.Deleting short stitchesIf embroidery data other than our original patternsare used, the stitch length may be too short,possibly resulting in the thread or the needlebreaking. In order to prevent this problem fromoccurring, the machine can be set to delete stitcheswith a short stitch length. Stitches with a length lessthan that specified in this function, can be deleted.When the embroidery machine is purchased, “0.3”was selected (delete stitches with a length of 0.3mm or less).1Touch and to select the stitchlength.The desired size is displayed.• A value between 0 and 1 millimeters if theunits of measurements is set to “mm” (or avalue between 0 and 0.04 inch if the unitsof measurements is set to “inch”) can bespecified.Note● If the setting is changed from the previoussetting, the new setting is only applied tothe next embroidery.
