Baby Lock Regalia BLRG20 Service Manual

Contents

Page 8Regalia Service ManualSection 1: General Observation: Quick Set TensionAssembly - Replacing the Take-up Spring NOTE: the detent washer is placed with thedetents away from the knob on the Quick SetTension assembly1. Remove the following parts from the assembly:knob, detent washer, cone spring with long tail,spring base and two tension discs.2. Loosen the set screw under the Quick SetTension assembly on the front cover casting andpull the tension assembly out just far enough toloosen the set screw on the barrel (step 4), sothe center split bolt can be removed from theassembly3. Loosen the set screw on the barrel, remove thecenter split bolt4. Wiggle and push in on the tail of the spring untilthe take-up spring pops out of the barrel.Â IMPORTANT: Be careful not to pull theassembly out too far so as to pull off thewire tie internally, which protects thetension assembly cable from interferingwith the take-up lever.