INSTALLATIONOIC INSTALLATION3 - 12 I-E96-192-5A®IIOIC422 Console Wiring Connections and CablingThe IIOIC422 console is internally wired when it is shipped.Connect the AC power and any peripheral devices. Refer toSection 6 for specific instructions on installing and configuringreplacement components.1. Wire AC power to the proper terminals of the power entrypanel. Refer to Figure 3-8 for AC input terminal location.NOTE: Verify that the incoming voltage meets the rating on the labelof TB1.2. Connect only 120/240 VAC at 50/60 hertz into the termi-nal block on the power entry panel.Figure 3-9 shows the IIOIC422 cable connections. The circlednumbers represent the cables. Table 3-3 contains the list ofthose cables and connection descriptions.NOTE: If remote monitors are being installed in the OIC console, besure they are powered using the same power source and ground asthe OIS and OIC console to reduce the chance of communicationproblems on the network. Failure to do so may cause data to bechanged or lost.Figure 3-7. IIOIC422 Console 45 Degree Wedge Dimensions50.82.00493.819.44TP35320B615.424.23254.510.02956.637.66395.715.58 482.619.001089.742.90IICPI02 DIMENSIONSMILLIMETERSINCHES482.619.00791.531.16885.234.85
