INSTALLATIONOPERATOR INTERFACE DEVICESI-E96-192-5A 3 - 21IIOIC424 Panel Mount Wiring Connections and CablingThe IIOIC424 panel mount console is internally wired when itis shipped. Connect the AC power and any peripheral devices.The power entry panel provides line filtering, transient sup-pression and a ten-amp circuit breaker.1. Plug in AC power to the power connector.2. Refer to Figure 3-15 for AC input location.Cable connections are shown in Figure 3-16. Table 3-5 is a listof the cable connections.OPERATOR INTERFACE DEVICESThis section contains information and the installation instruc-tions for the operator and engineering keyboards, mouse/trackball and the annunciator display panels.Operator KeyboardThe KEYBOARD port on the keyboard interface assembly is forthe mylar operator keyboard. The 0.9 meters (3-foot) longcoiled cord can be stretched to 2.4 meters (8 feet). See Figure3-17. Refer to Table 7-1 for the operator keyboard partnumber.Engineering KeyboardEach IIOIC42 console supports an additional engineering key-board (QWERTY) (Figure 3-18). A 6-pin mini DIN to 5-pin DINadapter is supplied with the keyboard. All OIC consoles have afive-pin DIN connector located on the keyboard interfaceboard. Power does not have to be removed from the OIC con-sole before plugging in or unplugging the keyboard. Initializingthe system is not needed after plugging in or unplugging thekeyboard. Keyboard mapping information is in the operationinstruction.Figure 3-15. IIOIC424 Panel Mount Power Entry Panel ConnectionsTP36136D .TO ADP (IF USED) TO KEYBOARDPORTJ2I/O PW R ADP PW R FAN PW RCPU INPUT PW RPOW ERW RISTSTRAPPEP INPUT PW RJ1TO COMMUNICATIONPORTTO KEYBOARDCONNECTOR PANELKEYBOARDRESETDEGAUSSADP2NO1NO4NO3NO6NO5NO2NC1NC4NC3NC6NC5NC2CO1CO4CO3CO6CO5CODI2+DI1+DO2+DO1+DI2–DI1–DO2–DO1–
