Baldor 22H series Installation & Operating Manual

Contents

Baldor 22H series Installation & Operating Manual Manual pdf 15 page image

Section 1General Information3-4 Receiving & Installation MN722Control Installation The control must be securely fastened to the mounting surface. Use the four (4)mounting holes to fasten the control to the mounting surface or enclosure.Through the Wall Mounting Control sizes E and F are designed for panel or through the wall installation. To mount acontrol through the wall, an optional Through the Wall mounting kit must be purchased.These kits are:Kit No. DescriptionV0083991 Size E control Through the Wall mounting kit.V0084001 Size F control Through the Wall mounting kit.Procedure:1. Refer to Section 7 of this manual for drawings and dimensions of the Throughthe Wall mounting kits. Use the information contained in these drawings tolayout the appropriate size hole on your enclosure and wall.2. Cut the holes in your enclosure and wall.3. Locate and drill holes for mounting hardware as shown in the drawings.4. Cut foam tape and apply to perimeter of opening as shown.5. Secure the four (4) brackets to the exterior of the panel with the hardwareprovided.6. Secure the control to the panel using the hardware provided.