Baldor 22H series Installation & Operating Manual

Contents

Baldor 22H series Installation & Operating Manual Manual pdf 67 page image

Section 1General Information4-8 Programming & Operation MN722Program Mode ContinuedChanging Parameter Values when Security Code Not UsedUse the following procedure to program or change a parameter already programmed intothe control when a security code is not being used.The example shown changes the operating mode from Keypad to Bipolar.Action Description Display CommentsApply Power Keypad Display shows thisopening message.Logo display for 5 seconds.If no faults and programmed forLOCAL operation.Display mode. Stop LED on.Press PROG key Access programming mode.Press or key Scroll to Level 1 Input Block. Press ENTER to access INPUTblock parameter.Press ENTER key Access Input Block. Keypad mode shown is thefactory setting.Press ENTER key Access Operating Modeparameter.Keypad mode shown is thefactory setting.Press key Scroll to change selection. At flashing cursor, select desiredmode, BIPOLAR in this case.Press ENTER Save selection to memory. Press ENTER to save selection.Press key Scroll to menu exit.Press ENTER key Return to Input Block.Press DISP key Return to Display Mode. Typical display mode.