Banner Sure Cross DXM150 Series Instruction Manual

Contents

Banner Sure Cross DXM150 Series Instruction Manual Manual pdf 33 page image

Potentiometer Sense (DXM150 only)A potentiometer input is created from two inputs: a voltage source (pin 45) that supplies a voltage to thepotentiometer and an input sense (Potentiometer Sense) to read the resistance. See Using Universal Inputs to Reada Potentiometer (p/n b_4462775) for more information.Thermistor InputA thermistor input must use a 10k thermistor between ground and the universal input. The thermistor must be a 10kNTC (Banner model number BWA-THERMISTOR-002) or equivalent. Select the temperature conversion of degreesC (default) or degrees F by writing to the Modbus registers defined in I/O Base Boards.Example: Configure Input 1 as a Synchronous Counter1. Connect the DXM to the PC.2. Launch the DXM Configuration Software software.3. Connect to the DXM by selecting the Device > Connection Settings menu option. You may connect using eitherUSB or Ethernet.4. Select a COMM port from the drop-down list and click Connect.5. Click on the Register View tab on the left part of the page.6. Change the Source Register selection to I/O Board Registers.7. In the Write Registers area, write Modbus register 4908 to 1 to enable counting on the rising edge of the inputsignal.8. Read Modbus registers 4910 and 4911 to get the 32-bit value of the count.Example: Change Universal Input 2 to a 0 to 10 V dc Input1. Connect the DXM to the PC.2. Launch the DXM Configuration Software software.3. Connect to the DXM by selecting the Device > Connection Settings menu option. You may connect using eitherUSB or Ethernet.4. Select a COMM port from the drop-down list and click Connect.5. Click on the Register View tab on the left part of the page.6. Change the Source Register selection to I/O Board Registers.7. Write a 3 to Modbus register 3326 on Modbus Slave ID 200 (I/O board).8. Cycle power to the device.9. Using the Register View tab, read register 3326 to verify it is set to 3.Example: Change Analog Output 1 to a 0 to 10 V dc Output1. Connect the DXM to the PC.2. Launch the DXM Configuration Software software.3. Connect to the DXM by selecting the Device > Connection Settings menu option. You may connect using eitherUSB or Ethernet.4. Select a COMM port from the drop-down list and click Connect.5. Click on the Register View tab on the left part of the page.6. Change the Source Register selection to I/O Board Registers.7. Set jumper 1 on the I/O base board to the 0 to 10 V position. Refer to the base board image for the analog outputjumper position.8. Write a 3 to Modbus register 4008 on Modbus Slave ID 200 (I/O board).9. Cycle power to the device.10. Using the Register View tab, read register 4008 to verify it is set to 3.Example: Change Universal Input 8 to Read a Potentiometer InputFigure 21. Default jumper position2.7 V 4.2 VPower pin 45GroundPot sense Ui8pin 35Pwr Inpin 45Vbatt1 23 45 6Sure Cross® DXM150 and 1500-Bx Wireless Controllerswww.bannerengineering.com - Tel: + 1 888 373 6767 33