Figure 46. Cloud Services screen8.6.2 Configure your Ethernet ConnectionTo send email based on a threshold rule or to email log files, first define the network and email servers. When selectingEthernet, go to the Settings > Ethernet screen.1. To define the Ethernet IP address, give the DXM a static IP address. In most cases you may select the device to useDHCP and have the IP address automatically assigned.2. DNS settings are not typically required. The DXM uses a public service to resolve Domain names, but if the networkconnection does not have Internet access, the DNS settings may be required.Figure 47. Settings > Ethernet screen8.6.3 Configure your Cellular ConnectionTo use a cellular connection, select Cell as the network connection on the Settings > Cloud Services screen (see Configurethe DXM Controller for a Cellular Modem on page 40). The Cellular screen does not display unless the Network interface isset to Cell.Using a 4G LTE cell module requires a cellular plan; follow the instructions on p/n 205026 to activate a cell modem.1. On the Settings > Cellular screen, select your cellular modem from the drop-down list.2. Set the APN.• If you are using a Banner 4G LTE Verizon Module (LE910), set the APN to vzwinternet.• If you are using an Emnify 3G GSM Cellular Radio (HE910), set the APN to EM. This module does not requirean APN username or password.• If you are using a third-party SIM card, the APN, APN Username, and Password must be provided by thecellular service provider.Sure Cross® DXM150 and 1500-Bx Wireless Controllerswww.bannerengineering.com - Tel: + 1 888 373 6767 59
