Cabletron Systems CyberSWITCH CSX200 Configuration Manual

Also see for CyberSWITCH HSIM-W6: Setup guide User guide User guide Installation guide

Contents

Wide Area Time Slot Configuration WindowsQuickSET Configuration Guide95Wide Area Time Slot Configuration WindowsThis section contains the following Wide Area Time Slot Configuration windows:Wide Area Frame Relay Time Slot Configuration WindowWide Area PPP Time Slot Configuration WindowWide Area HDSL Time Slot Configuration WindowWide Area HDLC Time Slot Configuration WindowWide Area Frame Relay Time Slot Configuration WindowThe Wide Area Frame Relay Time Slot configuration window shown in Figure 103 displays whenyou click on the Next>> button in the Wide Area T1 or DI configuration windows if you chooseFrame Relay as the WAN Protocol. The Wide Area Frame Relay Time Slot configuration windowshown in Figure 104 on the following page, displays when you click on the Next button in theWide Area E1 configuration window.Figure 103 Frame Relay Time Slot Configuration Window - T1, DIFrame Relay Time Slots — A full line consists of 24 Time Slots (T1 and DI) or 31 Time Slots(E1), each capable of up to 64 Kbps throughput. If you are leasing an entire line from your serviceprovider, you may select all the Time Slots by clicking the Select All button. A “check mark”displays in the selected box. If you have leased a portion of a fractional T1 or E1 line, your serviceprovider will tell you which Time Slots are allocated for your use. If you are configuring aWPIM-DI Time Slot table, any available Time Slots that are not checked are mapped to the DIInterface. If you lease an entire T1 line, any Time Slots that are not selected in the Frame Relayconfiguration window are used by the device connected to the DI interface.