Cabletron Systems CyberSWITCH CSX200 Configuration Manual

Also see for CyberSWITCH HSIM-W6: Setup guide User guide User guide Installation guide

Contents

QuickSET Configuration GuideiNOTICECabletron Systems reserves the right to make changes in specifications and other informationcontained in this document without prior notice. The reader should in all cases consult CabletronSystems to determine whether any such changes have been made.The hardware, firmware, or software described in this manual is subject to change without notice.IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL,INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUTNOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL ORTHE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEENADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCHDAMAGES. 1999 by Cabletron Systems, Inc., P.O. Box 5005, Rochester, NH 03866-5005All Rights ReservedPrinted in the United States of AmericaOrder Number 9032691-03 April 1999Cabletron Systems and QuickSET are registered trademarks and CyberSwitch is a trademark ofCabletron Systems, Inc.All other product names mentioned in this manual may be trademarks or registered trademarks oftheir respective companies.FCC NOTICEThis device complies with Part 15 of the FCC rules. Operation is subject to the following twoconditions: (1) this device may not cause harmful interference, and (2) this device must accept anyinterference received, including interference that may cause undesired operation.NOTE: This equipment has been tested and found to comply with the limits for a Class A digitaldevice, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonableprotection against harmful interference when the equipment is operated in a commercial environment.This equipment uses, generates, and can radiate radio frequency energy and if not installed inaccordance with the operator’s manual, may cause harmful interference to radio communications.Operation of this equipment in a residential area is likely to cause interference in which case the userwill be required to correct the interference at his own expense.WARNING: Changes or modifications made to this device which are not expressly approved by theparty responsible for compliance could void the user’s authority to operate the equipment.Only qualified personnel should perform installationprocedures.