$Cabletron Systems CyberSWITCH CSX200 Configuration Manual Manual pdf 95 page image$

Cabletron Systems CyberSWITCH CSX200 Configuration Manual

Also see for CyberSWITCH HSIM-W6: Setup guide User guide User guide Installation guide

Contents

$Cabletron Systems CyberSWITCH CSX200 Configuration Manual Manual pdf 95 page image$

Wide Area - 1 and 2 Configuration WindowsQuickSET Configuration Guide79Protocol — Displays the active protocol for the Wide Area interface. The Protocol panel lets youselect one of four protocols: Point-to-Point, HDLC (High Level Data Link Control), Frame RelayPoint-to-Point, Frame Relay Point-to-Multipoint.High Level Data Link Control lets you select either Full or Fractional mode for all or half of thetime slots (for a single interface number and alias). Point-to-Point protocol lets you select aninterface number for each time slot. Frame Relay Point-to-Multipoint allows only one interfacenumber and alias, but allows multiple DLCIs. Frame Relay Point-to-Point allows multipleinterface numbers, aliases, and DLCIs.Link Management Protocol — If you selected Frame Relay protocol, this field displays Q.933Annex A, T1.617 Annex D, and T1.617 Annex D 1994. The default is T1.617 Annex D. When youhave completed Wide Area DI configuration, click on the Next>> button, and go to the Wide AreaFrame Relay Time Slot Configuration Window or the Wide Area PPP Time SlotConfiguration Window section.DLCI Setup ButtonThe DLCI Setup button displays the DLCIs window shown below in Figure 86. The DLCIswindow shows a list of Interface Numbers, Aliases, and DLCIs (Data Link Connection Identifiers).Use the Add button and the Add DLCI window to make new entries to this table. Use the Deletebutton to delete the entry highlighted. Click Done when you have finished.Figure 86 DLCIs window and Add DLCI windowWhen you have finished, click on the Next>> button, and go to the Wide Area Time SlotConfiguration Windows section, for the appropriate time slot window.