Cabletron Systems ELS10-26TX User Manual

Also see for SmartSTACK 10 ELS10-26: Reference guide Getting started

Contents

4-12Monitoring and Managing Your ELS10-26LCM displays the current IP address table, for example:To change the subnet mask, at the LCM prompt:1. Type ipaddr For example, ipaddr 6 192.138.217.40 255.255.240.0 would setthe subnet mask for port 6 to 255.255.240.0. LCM responds byredisplaying the address table.To assign a new IP address, refer to Section 3.1.4.5.4 Changing a Community NameA community name is similar to a password. You use the samesteps to assign a new community name or to change an existingcommunity name. This sets the MIB variable sxadminAnyPass. Youcan then enter a community name to perform any SNMP sets.To assign a community name, at the LCM prompt:1. Type community2. Enter the old community name.If one has not been assigned, you do not need to enteranything. LCM prompts you for the new community name.Note: When you change the subnet mask for a port, you must also enterthe IP address for that port. Make sure you enter the IP address forthe port correctly; whatever you enter becomes the IP address.Port IP Address Address Mask MAC Address1234567192.138.217.10.0.0.0192.138.217.100.0.0.00.0.0.0192.138.217.20192.138.217.50255.255.255.0255.0.0.0255.255.255.0255.0.0.0255.0.0.0255.255.255.0255.255.255.000:40:27:00:06:1f00:40:27:00:06:c300:40:27:00:06:3e00:40:27:00:03:7a00:40:27:00:05:c700:40:27:00:04:4a00:40:27:00:06:9e