KBU 64 User Manual80-10100000-094–44.3 Active Channel CommandAlters the active channel reference (the active channel is the channelwhich will be effected by all subsequent configuration commands).The command line prompt indicates which of the channels is active:1> indicates that B1 (channel using the LINK 1/USER 1connectors on your KBU 64) is currently the active channelfor commands2> indicates that B2 (channel using the LINK 2/USER 2connectors on your KBU 64) is currently the active channelfor commands.To alter the active channel enter ‘1’ or ‘2’ followed by [CR] i.e.:1> 2[CR] alters the active channel from B1 to B2.4.4 Default ConfigurationYour KBU 64 has been shipped with factory default settings for each ofthe configuration options.To display a status screen showing the current configuration settings forboth the B1 and B2 channels, at the command line prompt, type:1> STATUS[CR]Note that as well as detailing your KBU 64 configuration settings, anactivity status report on the ISDN and Kilostream lines is also displayedtogether with an indicator showing to which of these the USER interfaceis currently connected.
