KBU 64 User Manual80-10100000-094–8This system day will be implemented as soon as you have pressed thecarriage return key, terminating the command line.4.7.1 Viewing the Current System Time, Date and DayThe current system time, date or day can be viewed by typing:1> TIME[CR]1> DATE[CR]1> DAY[CR]as required.4.8 Defining the Line CharacteristicsTo enable compatibility with your DTE and Kilostream line operation, theactual line speed and data protocol of each of your USER ports(channels 1 and 2) must be correctly configured within the KBU 64.The default settings for both channels 1 and 2 are set to operatesynchronously at 64Kbit/s.4.8.1 Altering the ISDN Line Protocol DefinitionTo see the current protocol setting of both channels of your KBU 64,issue the STATUS[CR] command at the command line prompt. Normallydata protocol for traffic on both channels will be synchronous.If the requirement for either of your DTEs is for asynchronous data, youmust alter your KBU 64’s configuration to reflect this.Note that it may first be necessary to change the SPEED parameter to aspeed which can be both synchronous and asynchronous (600 to38k4bit/s), otherwise the asynchronous DATA setting parameter changewill not be accepted by the KBU 64.
