Cabletron Systems SMARTSWITCH ROUTER 9032578-05 User's Reference Manual

Contents

Cabletron Systems SMARTSWITCH ROUTER 9032578-05 User's Reference Manual Manual pdf 79 page image

SmartSwitch Router User Reference Manual 53ATM Sample Configuration 1Configuring an Interface on an Ethernet PortThere are two separate VLANs in this network, VLAN A and VLAN B. VLAN A isconnected to Ethernet port et.2.1 on SSR1, and VLAN B is connected to Ethernet port et.1.1on SSRSSR2.Apply an interface on both Ethernet ports. Creating an interface on an Ethernet portassigns a network IP address and submask on that port.Creating a Virtual ChannelCreate a VC to connect ATM port at.1.1 on SSR1 to ATM port at.2.1 on SSR2. Use thefollowing command to create a virtual channel on SSR1 with vpi=0 and vci=100:You must now configure a corresponding vpi/vci pair on ATM port at.2.1. Use thefollowing command to create a virtual channel on SSR2 with vpi=0 and vci=100:Note that you are using the same vpi and vci on both SSRs. This establishes a common VCfrom one ATM port to another ATM port.Defining an ATM Service ClassAfter creating a VC connection from ATM port at.1.1 to at.2.1, the next step is to define anATM service class for this connection.The following command lines defines a service class named ‘cbr1m’ on both SSR1 andSSR2 where CBR is the service category and peak cell rate is set to 10000 kcells/second:ssr1(config)# atm create vcl port at.1.1.0.100ssr2(config)# atm create vcl port at.2.1.0.100ssr1(config)# atm define service cbr1m srv-cat cbr pcr-kbits 10000ssr2(config)# atm define service cbr1m srv-cat cbr pcr-kbits 10000