Introduction to Netlink Frame Relay Access Devices 1-17Throughout this manual are tables of valid and default values. To specify a default (ifone exists), press [Enter] in response to a prompt.Be careful; pressing [Enter] when it is not required may cause thenext prompt to automatically select the default choice.On-Line HelpEach screen menu displays the prompt Option:. Pressing [?] in response to this promptwill usually display a list of options. To make a selection, press either the function keyshown preceding the desired option or the character preceding the desired menu item.The list of options varies, depending on what menu is displayed; all the options aredescribed below. (Function key equivalents on an async terminal keypad are listed onpage 1-19.)F1: Select Another Record—displays the first prompt that appeared on your screenafter you made your menu selection, so you can specify another record.F2: Next Record or Remote Refresh:Next Record—displays the next sequential record on your screen for verification,modification, or deletion.Remote Refresh—refreshes a remote display.F3: Exit menu—returns you to the previous menu, saving any changes you have made.Some menus have two sets of values: Database and System Memory.Changes will affect only the set that was enabled, unless [F7] is pressedfirst to update the other side. Database and System Memory values aredescribed on page 3-8 for Node Defaults and page 5-4 for Ports.F4: Exit menu or Delete Record or Clear Max Stats:Exit Menu—appears at the Main Menu, and exits to the Port Status display (Figure1-8). To return to the menu, you must enter the node's password. (This feature isfor security, to protect menu-level operations from unauthorized access.)Delete Record—initiates the deletion of the displayed record. A record for thisport number, containing all the default values, will remain in the database.Deleting a port record for an existing port will immediatelydisable the port.Clear Max Stats—on statistics displays, clears the maximum/cumulative valuesfrom the display (restarting them at the current values).
