Manual Operation9 (Off): Turns the entire climate control system off.Outside air still enters the vehicle and is directed tothe floor. The airflow direction and temperature can beadjusted, as indicated below.If the temperature is adjusted while the system is off,the display will light to show the current settings.w x (Driver's Temperature Controls): Press theup or down buttons next to the fan control to manuallyincrease or decrease the temperature inside thevehicle.w x (Passenger's Temperature Controls): Press theup or down buttons next to the air delivery mode controlto manually increase or decrease the temperature forthe front passenger. If the passenger climate controlsystem is off, pressing one of these buttons turns it on.9 (Fan Control): Turn clockwise or counterclockwiseto increase or decrease the fan speed. Turning thiscontrol completely counterclockwise will turn on theautomatic fan operation. If the airflow seems low whenthe fan speed is at the highest setting, the passengercompartment air filter may need to be replaced. SeePassenger Compartment Air Filter on page 4‑43.Air Delivery Mode Control: Turn clockwise orcounterclockwise to change the current airflow mode.Select one of the following:AUTO: Turns on the automatic delivery modeoperation.F (Vent): Air is directed to the instrument panel outlets.* (Bi-Level): Air is divided between the instrumentpanel and the floor outlets. In automatic operation,cooler air is directed to the upper outlets and warmerair to the floor outlets.7 (Floor): Air is directed to the floor outlets withsome air directed to the side window outlets and thewindshield.If recirculation is selected, it only stays on forthree minutes to reduce windshield fogging.W (Floor/Defog): This mode clears the windowsof fog or moisture. Air is directed to the floor outlets,with some air going to the side window outlets andwindshield. When selected, the system turns offrecirculation and runs the air conditioning compressorunless the outside temperature is at or below freezing.The recirculation mode cannot be selected while in thefloor/defog mode.4-38InformationProvidedby:
