Black plate (49,1)Cadillac SRX Owner Manual - 2011Instruments and Controls 5-49If you live in Canada, or you arehaving difficulty programming agate operator or garage door openerby using the “Programming theUniversal Home Remote System”procedures, regardless of whereyou live, replace Step 2 under“Programming the Universal HomeRemote System” with the following:2. Continue to press and holdthe Universal Home Remotebutton while you press andrelease every two seconds (cycle)the hand-held transmitter buttonuntil the frequency signal hasbeen successfully accepted bythe Universal Home Remote.The Universal Home Remoteindicator light will flash slowly atfirst and then rapidly. Proceed withStep 3 under “Programming theUniversal Home Remote System”to complete.Universal Remote SystemOperationUsing Universal Home RemotePress and hold the appropriateUniversal Home Remote buttonfor at least half of a second.The indicator light will come onwhile the signal is being transmitted.Erasing Universal HomeRemote ButtonsAll programmed buttons should beerased when the vehicle is sold orthe lease ends.To erase all programmed buttons onthe Universal Home Remote device:1. Press and hold down the2 outside buttons until theindicator light begins toflash, after 10 seconds.2. Release both buttons.Reprogramming a SingleUniversal Home RemoteButtonTo reprogram any of the threeUniversal Home Remote buttons:1. Press and hold the desiredUniversal Home Remote button.Do not release the button.2. The indicator light will begin toflash after 20 seconds. Withoutreleasing the button, proceedwith Step 1 of the section“Programming the UniversalHome Remote System.”If you have questions or needhelp programming the UniversalHome Remote System,call 1‐800‐355‐3515 or go towww.homelink.com. You may alsocall the customer assistance phonenumber under Customer AssistanceOffices (U.S. and Canada) onpage 13‑5 or Customer AssistanceOffices (Mexico) on page 13‑5.
