U ser 's GUide — 37The selected Drill Size is displayed along with its decimal Inchequivalent. If the entered value doesn’t match a Drill Size, the nextsmaller size is displayed. You can toggle through the availablesizes in increasing order with either the D key or the + key. The- key displays the available sizes in decreasing order. To set thedisplayed Drill Size, press O (or any other key).Numeric Drill Size entryEnter a #36 Drill and toggle through the next larger availablesizes:KeySTROKe DISPLAyOO 0.1. Enter the Drill Size:36D 36 DRILL SIZe $ 0.1065 INCH2. Display the next larger available sizes:D 2_75 MM DRILL SIZe $ 0.1083 INCHD 7/64 DRILL SIZe $ 0.1094 INCHD* 35 DRILL SIZe $ 0.1100 INCH* Repeated presses of D display the next larger Drill Sizes. The +and - keys will toggle forward and backward, respectively, through allavailable Drill Sizes.Letter Drill Size entryYou can enter letter Drill Sizes by selecting an alphabet charactervia Alpha Mode (g8) and then storing it using the D key. Thedesired letter can be selected by toggling through Alpha Modeuntil the letter is reached or by specifying the numerical order ofthe letter within the alphabet prior to entering Alpha Mode. Bothmethods are shown below.Select Drill Size E by toggling though Alpha Mode. Then, selectDrill Size G by entering the numerical order of the letter (the letterG is 7th in the alphabet).(cont’d)