California Instruments 801RP Series User And Programming Manual
Also see for 801RP Series: Training manual
                                                                                     | |
Contents
| 
User and Programming Manual - Rev P California Instruments4.2. How to...This chapter covers some common tasks that are often performed with an AC power source.These examples are written in a How to... format and provide step by step instructions onhow to set up the AC Source for a specific task.4.2.1. Set the OutputOutput parameters are Voltage, Frequency and Current Limit.1. Disable the output by pressing the OUTPUT button. The LED above the button will turnoff.2. Use the left shuttle to set the output voltage. Clockwise will increase the output, counterclockwise will reduce the output. The display above the shuttle will show the voltagesetting.3. Use the right shuttle to set the frequency and current limit. The Frequency/Current selectbutton will define the function of the shuttle and the display above it. The Frequency orCurrent LED will turn on to indicate the function controlled by the right shuttle.4. Enable the output by pressing the OUTPUT button.4.2.2. Slewing Output ValuesThe output parameters can be slewed using the shuttles.1. Enable the output by pressing the OUTPUT button. The LED above it will turn on.2. Use the left shuttle to set the output voltage. Clockwise will increase the output,counter clockwise will reduce the output. The display above the shuttle will show thevoltage setting.3. Use the right shuttle to set the frequency and current limit. The Frequency/Currentbutton will define the function of the shuttle as indicated by the display above it. TheFrequency or Current LED will turn on to indicate the function in control.4.2.3. View Current MeasurementsCurrent measurements can be called up as follows:1. Press the Frequency/Current button to select the Current function.2. Immediately the Frequency/Current display will show the measured current.3. Moving the right shuttle will interrupt the current measurement. The display will showthe current limit value.4. After a short delay the display will revert back to show the measured current.October 2005 RP Series16 |
Related manuals for California Instruments 801RP Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine